top of page

Transfer "How To" Guide

Blue Wave.jpg

​Instructions:

  1. To begin, make sure the area you are applying the transfer to is clean and free of any debris. For best results, make sure the surface you are using is primed and has an even surface. Take a dry towel and clean off/dust off the area.

  2. Position the transfer where you would like to apply it. Remove the protective sheet and place it onto the surface, use masking tape to secure and help keep the transfer in place. Use a transfer tool or applicator to rub the transfer design onto the surface. Note: depending on the transfer design and complexity, you may have to rub the transfer with moderate force. Be sure to rub evenly and all over the design to ease the release of the transfer

  3. Once done, gently remove the acetate protector sheet to reveal transferred design. If any pieces did not transfer, position the sheet back onto the surface and rub again. To extend the life of your transfer you may use a water based sealer or a clear wax sealant. 

blue wave 4.jpg
bottom of page